Gradall 534B (9103-1380) Operation Manual Manuel d'utilisateur télécharger pdf (Page 24)

Attachments

Although the carriage/fork combination is most

frequently used, a number of other attachments

available for use with the handler. 180ø and 100ø

swing forks are available. A material bucket can be

provided for light duty work. A truss boom is

available to extend maximum reach and height and

can be fitted with a winch when required. Consult

your Gradall Material Handler Dealer for infor-

mation on attachments designed to solve special

material handling problems.

Attachments Capacities

The Rated Capacity Chart located on left side of

dashboard indicates maximum capacities for

handlers equipped with standard carriage/fork

combination. These capacities apply only to

standard carriage, fork combination and cannot be

used for other attachments.

Attachment Installation

A serial number plate Is attached to all attachments

and indicates maximum capacity for that

attachment. However, the capacity shown on

this plate may be incorrect in relation to your

machine.

Refer to Attachment Capacity Plate located below

Serial Number Plate on right cab wall for correct

maximum capacity for all attachments furnished

with your machine. If attachment in question is not

listed on this plate contact factory for maximum

capacity.

Refer to Operating Procedures and Techniques

section for instructions on proper use of

information shown on capacity plates.

Depress button and remove lock pin from quick

switch latch pin.

Depress handle fully to engage latch pin in

attachment and install lock pin in latch.

Raise handle to retract latch pin fully.

Position boom head attachment pin fully in recess

of attachment. Tilt upward slightly to assure full

engagement.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Pas de commentaire

Gradall 534B (9103-1380) Operation Manual Manuel d'utilisateur Page 24